Menu
Your Cart
20% OFF on all products Shop now

50W Laser Power Supply for Co2 laser Engraving Machine

50W Laser Power Supply for Co2 laser Engraving Machine
50W Laser Power Supply for Co2 laser Engraving Machine
50W Laser Power Supply for Co2 laser Engraving Machine
50W Laser Power Supply for Co2 laser Engraving Machine
50W Laser Power Supply for Co2 laser Engraving Machine
  • Stock: In Stock
  • Model: 50W
190 samples sold
$0.00
Ex Tax: $0.00

Available Options

Specification

Input AC Voltage

AC220V or AC110V

Input DC Voltage

DC 300V or DC150V

Input AC Frequency

47-440Hz

Max. Output Voltage

22KV

Max. Output Current

22mA(Depends on Laser tube)

Efficiency

91%

Over Current Protection

130% of Max.Current

Open circuit Protection

Yes (For short time)

Cooling

Fan Cooling

Voltage Range of High Level Control

Not Less Than3V

Voltage Range of Low Level Control

Not More Than0.8V

Working Temperature

-30 - +65 Degree Centigrade

Humidity

20-85%RH(No Dew)

 
Withstand
Voltage

Input-Output

AC1500V/MinNot More Than10mA

Input-Shell

AC1500V/MinNot More Than10mA

Output-Shell

Connected

Insulation

Not Less Than 50MOHM(DC500V)

Leakage Current

Not Less Than 1mA(AC220V)Not More Than 0.5 mA(AC110V)

Shock Resistance

Amplitude: 0.5mm, Frequecy:10-55Hz, 3D Dretion:2 Hours

MTBF

Not Less Than30,000hours

Full Load 60 Degree Centigrade test

12Hours

7 Seconds Start/Stop Test

500 Times

Dimension(LXWXH)

171mmx161mmx91mm


 

Features

This new type laser power supply adopts module design . It can automatically detect and display laser power supply’s signal and water protection signal. All model power supply’s installation holes are the same with each other which makes professional assembly line very each in factory. Also it is good for machine user’s replacement or upgrade.

 

This laser power supply adopts zero current and half bridge soft switch circuit, it makes the power supply have high efficiency and quick response speed. Thus it is easy to match with CO2 laser tube made by any factories.

 

This laser power supply is easy to be controlled, it is suitable to High or Low level signal. The TTL level can control start or stop of laser output. While the power supply has emergency protection switch which can indicate water through and ventilation.

 

The laser output power can be adjusted by 0-5V analog signal or PWM signal.

 

This laser power supply has open cirsuit protection function. When protective earthing is good, the laser power supplycan be in open circuit status during short time. This function canprotec power supply when laser tube burst.

 

Aging test:Each laser power supply must pass this test which is taken at 60 degree centigrade for 12 hours in full load status. And the power supply must start and stop at each 7 seconds for 500 times. In this way we can ensure the laser power supply is qualified.

 

Terminal definition, indicator and test








Write a review

Note: HTML is not translated!
Bad Good