- Stock: In Stock
- Model: W1
Specification
Model:W1 | |
Length(mm):1100 | Diameter(mm):φ80 |
Rated Power(w):75 | Max Power(w):90 |
Service life:15000 hours | Warranty:540days |
Catalyst: Yes |
|
Installation Requirement
Make sure to follow the operation instruction of model W1 as shown in the illustration. The dedicated power P12 should be equipped. The positive pole of laser tube is in high voltage (the ignition voltage is 19kv). It may cause the following consequence when it is failed to follow the instruction: Arcing; the inner tube will be punctured by electricity and may cause water leakage.
Operation conditions
Water cooling: using purified water; 2 to 5 liter/minute; water temperature: 10℃-40℃.
Operate environment: temperature 2-40℃; Humidity 10-60%.
The working current: test current is 29mA. Maximum working current is 29mA. The running current must be kept below 27mA. The life span can reach 8,000 hours if the current is kept below 25mA. The ammeter must be connected to the negative electrode of laser tube.
When it is working under over-high current for long term, the negative pole will appear light yellow and the life span will be shortened rapidly.
To protect dust from going into the insulation sheath, please wrap it with plastic film.
Working Performance
Cutting function.
Engraving function: Auxiliary engraving. When the working current is 4mA and the tube is in the state of preionization, the laser can be used for high-frequency impulse engraving.
